Finnex Digital Heater Controller - HC-820M
- 1000 Watt Max Output Load with Dual Relay Protection
- Out fo Water Sensor Protection Audio Alert
- 1/10th Degree Temperature Calibration
- 3 Digit Digital Display & Control
- Over Heating Audio Alert
- Temperature Saving Memory Protection
- ± .5°F High Precision Accuracy
- Temperature Steady Low Variance Technology
The HC-820M controller uses an advanced digital processor that monitors and controls the water temperature in your aquarium. The heating controller receives temperature data from the remote sensor in the aquarium.
The remote sensor contains no bi-metallic contacts to arc, corrode or wear out. This allows the HC-820M to have precise control, keeping the water temperature stable while avoiding wide temperature swings common with low-quality aquarium controllers. The controller displays the current temperature, allowing you to easily make temperature adjustments on the front panel. Temperature can be adjusted by a tenth of a degree.
The remote sensor also functions as an automatic power cut-off switch. If the water level drops too low and exposes the temperature sensor to the air, power to the heater tube is turned off. This prevents over-heating of the aquarium, saving your prized aquarium life from harm or other hazards.
Maintenance: Secure the out-of-water sensor directly beneath the sensor cord clip, without any cord slack, and above the heating element at all times. Clean and confirm the out-of-water sensor is functioning properly every 30 days. Do not use heater if the out-of-water sensor is inoperative. Refer to the inspection manual for proper maintenance and care.
ATTENTION APEX USERS: The HC-820M is not compatible with the APEX controller series.